Frequently Asked Questions.
Here are some common questions about the ST-1 scaler table.
How long is turnaround time?
Your order may take up to 2 weeks before it’s shipped out. If you have not received an order confirmation, please email support@nwscalerdesigns.com
What is the ST-1 made from?
Table and all stands are laser cut from 14ga 304-2b stainless steel
What are the ST-1 dimensions?
The table is 24″ long, 12.5″ wide with a max height of 3″
What wheelbase does the ST-1 support?
The ST-1 supports a minimum wheelbase of 6.375″ and a maximum wheelbase of 18.5″
What about frame width compatibility?
The ST-1 is compatible with a minimum frame width of 2 3/4″ and a maximum frame width of 4.5″
What axles will the ST-1 hold?
The ST-1 can hold axles (with shafts) that measure from WMS (Wheel Mounting Surface) to WMS of 3.5″ wide to 9.25″ wide.
Yes, this will hold a stock AR60 with stock hexes. You can remove wider hexes if yours don’t fit, it will not affect the axle stands.
How adjustable is the 'Adjustable Link' included with the ST-1?
The ‘Adjustable Link’ included in the ST-1 kit can accommodate link lengths from 90mm to 150mm
What vehicles are compatible with the ST-1?
As far as we’ve tested, the following vehicles work with the ST-1:
- SCX10-2
- SCX10
- Vaterra Ascender
- TRX-4
- Wraith
What is the maximum weight the ST-1 can hold?
Not that we anticipate anyone throwing multiple vehicles on the ST-1, but it can hold around 25 lbs.
How much does the table weigh?
The assembled ST-1 kit is around 7 lbs.